pathfinder4x4vans@gmail.com

INSTALLATION INSTRUCTIONS

DANA 60 CUSTOM STEERING ARM

This steering arm is designed to be installed on top of the passenger side  steering knuckle. The arm faces forward, with the tapered hole facing  up. No special tools are required for installation.

First, remove the four ½ diameter bolts that hold the upper trunnion cap in  place. When you remove the cap, you will see a small spring protruding  from the center of the knuckle, there is no reason to remove it unless  you want to inspect the upper trunnion bushing. Wipe the top of the  knuckle clean and apply some silicone or a new gasket, which ever you  prefer. Then install the new trunnion cap supplies in the kit, followed  by the steering arm, 4 tapered locking split cones, 4 lock washers and 4 new 1/2 NF grade 8. bolts.

Remember, the tapered hole faces up. Install your drag link and tighten.

Note: Do not be concerned about the limited clearance between the drag link  and leaf spring when installing this kit on a Dana 60 equipped  Quadravan. There will be no interference.

It is not necessary to take your truck to the alignment shop after  installing the cross steering arm, unless you have disturbed the tie rod assembly. To center the steering wheel, rotate the sleeve assembly  clockwise or counter clockwise to make your adjustments. After your  steering wheel is where you want it, tighten the clamps on the adjusting sleeve.

Questions on parts or need to place an order? Call 385-202-7176 from 9:00 AM to 9:00
Monday-Friday (mtn time)

Sunday is Ok if you are unable to call during normal hours